Banner stand

These are the only things you will need for a banner stand, the ruler and snap off knife will be used for cutting the banner stand down to size. The roller will be used later when applying the banner to the banner stand.




After cutting the banner down, you need to then apply it to the banner stand top and base. You do this by putting the banner flush up to the top and making sure there isn't any banner hanging over the edge, then slowly take the tape of and apply it to the top of the banner stand.
Then you need to use a roller to make sure the banner inst going to come of from the strain.


Then you will need to repeat the process by doing it to the bottom of the banner stand.





After doing the top and bottom of the banner stand you will need to retract the banner into the banner stand so that you can stand it up. You do this by pulling the banner tight and taking a pin out, then slowly let the banner slip through you fingers making sure you don't catch it on the side to mark the banner.


























After doing this, you can then place the banner stand on the floor, and pull it out so that you can do a final check of the whole banner before you send it to the customer. Because if there are any marks or scuffs on the banner it would need a reprint.





When this has all been done, you then package it the same as you would a normal banner, this then gets sent to the customer by the courier.